ramips: fix D240 mini-PCIe power control GPIOs

In commit b11c51916cb9 ("ramips: Improve Sanlinking D240 config") I made
a mistake with regards GPIO numbering. And in addition to specifying the
wrong GPIO for controling the power of one of the mini-PCIe, I recently
discovered that the power of both slots can be controlled.

This patch specifies the correct GPIO for the left-most mini-PCIe slot
of the D240 (labeled power_mpcie2 since the slot is attached to SIM2),
and adds a GPIO that can be used to control the power of the other
mini-PCIe slot (labeled power_mpcie1).

Signed-off-by: Kristian Evensen <[email protected]>
[do not use the gpio active macros for the gpio-export value]
Signed-off-by: Mathias Kresin <[email protected]>

target/linux/ramips/dts/D240.dts

@@ -52,9 +52,16 @@
 
 		power_mpcie2 {
 			gpio-export,name = "power_mpcie2";
-			gpio-export,output = <GPIO_ACTIVE_LOW>;
-			gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
+			gpio-export,output = <1>;
+			gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>;
 		};
+
+		power_mpcie1 {
+			gpio-export,name = "power_mpcie1";
+			gpio-export,output = <1>;
+			gpios = <&gpio2 6 GPIO_ACTIVE_HIGH>;
+		};
+
 	};
 
 	gpio-leds {
@@ -94,6 +101,10 @@
 	status = "okay";
 };
 
+&gpio2 {
+	status = "okay";
+};
+
 &gpio3 {
 	status = "okay";
 };
@@ -157,7 +168,7 @@
 &pinctrl {
 	state_default: pinctrl0 {
 		default {
-			ralink,group = "i2c", "uartf", "wled", "spi refclk", "pa";
+			ralink,group = "i2c", "uartf", "wled", "spi refclk", "pa", "nd_sd";
 			ralink,function = "gpio";
 		};
 	};