ath79: enable Regulator support for target

Regulator support was enabled on all subtargets except for ath79-nand.
With Kernel 5.10, AT803x requires Regulator support, thus enabling on
the complete target, as ath79-nand requires AT803x.

While this is only required on Kernel 5.10, enable it also on 5.4. We
have no major size-constraint, so enabling it on 5.4 allows us to clean
up the occurences in the subtarget configuration.

Signed-off-by: David Bauer <[email protected]>

target/linux/ath79/config-5.10

@@ -162,6 +162,7 @@ CONFIG_PINCTRL=y
 CONFIG_RATIONAL=y
 CONFIG_REGMAP=y
 CONFIG_REGMAP_MMIO=y
+CONFIG_REGULATOR=y
 CONFIG_RESET_ATH79=y
 CONFIG_RESET_CONTROLLER=y
 CONFIG_SERIAL_8250_NR_UARTS=1

target/linux/ath79/config-5.4

@@ -211,6 +211,7 @@ CONFIG_PINCTRL=y
 CONFIG_RATIONAL=y
 CONFIG_REGMAP=y
 CONFIG_REGMAP_MMIO=y
+CONFIG_REGULATOR=y
 CONFIG_RESET_ATH79=y
 CONFIG_RESET_CONTROLLER=y
 CONFIG_SERIAL_8250_NR_UARTS=1

target/linux/ath79/generic/config-default

@@ -18,7 +18,6 @@ CONFIG_MTD_REDBOOT_PARTS=y
 CONFIG_MTD_SPLIT_EVA_FW=y
 CONFIG_PHY_AR7100_USB=y
 CONFIG_PHY_AR7200_USB=y
-CONFIG_REGULATOR=y
 CONFIG_REGULATOR_FIXED_VOLTAGE=y
 CONFIG_RTL8366RB_PHY=y
 CONFIG_RTL8366S_PHY=y

target/linux/ath79/mikrotik/config-default

@@ -28,7 +28,6 @@ CONFIG_NET_SWITCHDEV=y
 CONFIG_PCI_AR71XX=y
 CONFIG_PHY_AR7100_USB=y
 CONFIG_PHY_AR7200_USB=y
-CONFIG_REGULATOR=y
 CONFIG_REGULATOR_FIXED_VOLTAGE=y
 CONFIG_SPI_RB4XX=y
 CONFIG_UBIFS_FS=y

target/linux/ath79/tiny/config-default

@@ -9,5 +9,4 @@ CONFIG_NET_SWITCHDEV=y
 CONFIG_PHYLINK=y
 CONFIG_PHY_AR7100_USB=y
 CONFIG_PHY_AR7200_USB=y
-CONFIG_REGULATOR=y
 CONFIG_REGULATOR_FIXED_VOLTAGE=y