archs38: use generic 02_sysinfo

Currently archs38 sets a board name from compatible for no apparent
reason. Just use the compatible directly instead.

This theoretically removes a board name "generic" when no compatible
was present, however, there is no case where this "generic" board
name was actually used.

This also fixes an issue where snps,axs103 would not have been
properly detected anyway, as its case was not set up syntactically
correct.

Fixes: 73015c4cb378 ("linux: add support of Synopsys ARCHS38-based boards")

Signed-off-by: Adrian Schmutzler <[email protected]>

target/linux/archs38/base-files/etc/board.d/02_network

@@ -8,7 +8,8 @@
 board_config_update
 
 case "$(board_name)" in
-"arc-sdp"*|"arc-hsdk"*)
+snps,axs103|\
+snps,hsdk)
 	ucidef_set_interface_lan "eth0" "dhcp"
 	;;
 esac

target/linux/archs38/base-files/lib/arc.sh

@@ -1,43 +0,0 @@
-#!/bin/sh
-#
-# Copyright (C) 2016 OpenWrt.org
-#
-
-# defaults
-ARC_BOARD_NAME="generic"
-ARC_BOARD_MODEL="Generic ARC board"
-
-arc_board_detect() {
-	local board
-	local model
-	local compatible
-
-	[ -e "/tmp/sysinfo/" ] || mkdir -p "/tmp/sysinfo/"
-
-	model="$( cat /proc/device-tree/model )"
-	compatible="$( cat /proc/device-tree/compatible )"
-
-	case "$compatible" in
-	"snps,axs103""snps,arc-sdp")
-		board="arc-sdp";
-		;;
-        "snps,hsdk")
-                board="arc-hsdk";
-                ;;
-	"snps,nsim_hs")
-		board="arc-nsim";
-		;;
-	esac
-
-	if [ "$board" != "" ]; then
-		ARC_BOARD_NAME="$board"
-	fi
-
-	if [ "$model" != "" ]; then
-		ARC_BOARD_MODEL="$model"
-	fi
-
-	echo "$ARC_BOARD_NAME" > /tmp/sysinfo/board_name
-	echo "$ARC_BOARD_MODEL" > /tmp/sysinfo/model
-	echo "Detected $ARC_BOARD_NAME // $ARC_BOARD_MODEL"
-}

target/linux/archs38/base-files/lib/preinit/01_preinit_arc.sh

@@ -1,7 +0,0 @@
-do_arc() {
-	. /lib/arc.sh
-
-	arc_board_detect
-}
-
-boot_hook_add preinit_main do_arc