ath79: add support for TP-Link Archer C59v2

Add ath79 support for Archer C59v2, previously supported by ar71xx.

TP-Link Archer C59v2 is a dual-band AC1350 router based on
Qualcomm/Atheros QCA9561+QCA9886 chips.

Specification:

- 775/650/258 MHz (CPU/DDR/AHB)
- 128 MB of RAM (DDR2)
- 16 MB of FLASH (SPI NOR)
- 3T3R 2.4 GHz
- 2T2R 5 GHz
- 5x 10/100 Mbps Ethernet
- USB 2.0 port
- UART header on PCB

Flash instruction:
  - via web UI:
    1. Download openwrt-ath79-generic-tplink_archer-c59-v2-squashfs-factory.bin
    2. Login to router and open the Advanced tab
    3. Navigate to System Tools -> Firmware Upgrade
    4. Upload firmware using the Manual Upgrade form
  - via TFTP:
    1. Set PC to fixed ip address 192.168.0.66
    2. Download openwrt-ath79-generic-tplink_archer-c59-v2-squashfs-factory.bin
       and rename it to tp_recovery.bin
    3. Start a tftp server with the file tp_recovery.bin in its root directory
    4. Turn off the router
    5. Press and hold Reset button
    6. Turn on router with the reset button pressed and wait ~15 seconds
    7. Release the reset button and after a short time
       the firmware should be transferred from the tftp server
    8. Wait ~30 second to complete recovery.

Signed-off-by: Keith Maika <[email protected]>

target/linux/ath79/base-files/etc/board.d/01_leds

@@ -157,6 +157,7 @@ tplink,tl-wr842n-v3)
 	;;
 tplink,archer-c58-v1|\
 tplink,archer-c59-v1|\
+tplink,archer-c59-v2|\
 tplink,archer-c60-v1|\
 tplink,archer-c60-v2)
 	ucidef_set_led_switch "lan" "LAN" "tp-link:green:lan" "switch0" "0x1E"

target/linux/ath79/base-files/etc/board.d/02_network

@@ -59,7 +59,8 @@ ath79_setup_interfaces()
 	avm,fritz4020|\
 	pcs,cr3000|\
 	tplink,archer-c58-v1|\
-	tplink,archer-c59-v1)
+	tplink,archer-c59-v1|\
+	tplink,archer-c59-v2)
 		ucidef_set_interface_wan "eth1"
 		ucidef_add_switch "switch0" \
 			"0@eth0" "1:lan:1" "2:lan:4" "3:lan:3" "4:lan:2"

target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata

@@ -214,6 +214,7 @@ case "$FIRMWARE" in
 		;;
 	tplink,archer-c58-v1|\
 	tplink,archer-c59-v1|\
+	tplink,archer-c59-v2|\
 	tplink,archer-c60-v1|\
 	tplink,archer-c60-v2|\
 	tplink,archer-c6-v2)

target/linux/ath79/dts/qca9561_tplink_archer-c59-v2.dts

@@ -0,0 +1,86 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "qca9561_tplink_archer-c5x.dtsi"
+
+/ {
+	compatible = "tplink,archer-c59-v2", "qca,qca9560";
+	model = "TP-Link Archer C59 v2";
+};
+
+&leds {
+	usb	{
+		label =	"tp-link:green:usb";
+		gpios =	<&led_gpio 7 GPIO_ACTIVE_LOW>;
+		linux,default-trigger =	"usbport";
+		trigger-sources	= <&hub_port>;
+	};
+};
+
+&usb0 {
+	#address-cells = <1>;
+	#size-cells = <0>;
+	status = "okay";
+
+	hub_port: port@1 {
+		reg = <1>;
+		#trigger-source-cells = <0>;
+	};
+};
+
+&usb_phy0 {
+	status = "okay";
+};
+
+&spi {
+	status = "okay";
+	num-cs = <1>;
+
+	flash@0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <25000000>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			partition@0 {
+				label = "factory-boot";
+				reg = <0x000000 0x020000>;
+				read-only;
+			};
+
+			partition@20000 {
+				label = "u-boot";
+				reg = <0x020000 0x010000>;
+				read-only;
+			};
+
+			mac: partition@30000 {
+				label = "mac";
+				reg = <0x030000 0x010000>;
+				read-only;
+			};
+
+			partition@40000 {
+				compatible = "denx,uimage";
+				label = "firmware";
+				reg = <0x040000 0xe10000>;
+			};
+
+			partition@e50000 {
+				label = "tplink";
+				reg = <0xe50000 0x1a0000>;
+				read-only;
+			};
+
+			art: partition@ff0000 {
+				label = "art";
+				reg = <0xff0000 0x010000>;
+				read-only;
+			};
+		};
+	};
+};

target/linux/ath79/image/generic-tp-link.mk

@@ -60,6 +60,18 @@ define Device/tplink_archer-c59-v1
 endef
 TARGET_DEVICES += tplink_archer-c59-v1
 
+define Device/tplink_archer-c59-v2
+  $(Device/tplink-safeloader-uimage)
+  ATH_SOC := qca9561
+  IMAGE_SIZE := 14400k
+  DEVICE_MODEL := Archer C59
+  DEVICE_VARIANT := v2
+  TPLINK_BOARD_ID := ARCHER-C59-V2
+  DEVICE_PACKAGES := kmod-usb2 kmod-usb-ledtrig-usbport kmod-ath10k-ct ath10k-firmware-qca9888-ct
+  SUPPORTED_DEVICES += archer-c59-v2
+endef
+TARGET_DEVICES += tplink_archer-c59-v2
+
 define Device/tplink_archer-c60-v1
   $(Device/tplink-safeloader-uimage)
   ATH_SOC := qca9561