|
|
@@ -0,0 +1,173 @@
|
|
|
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
|
|
|
+/dts-v1/;
|
|
|
+
|
|
|
+#include <dt-bindings/gpio/gpio.h>
|
|
|
+#include <dt-bindings/input/input.h>
|
|
|
+
|
|
|
+#include "ar9331.dtsi"
|
|
|
+
|
|
|
+/ {
|
|
|
+ compatible = "tplink,tl-wr741n-v4", "qca,ar9331";
|
|
|
+ model = "TP-Link TL-WR741N/ND v4";
|
|
|
+
|
|
|
+ aliases {
|
|
|
+ serial0 = &uart;
|
|
|
+ led-status = &led_system;
|
|
|
+ };
|
|
|
+
|
|
|
+ gpio-keys-polled {
|
|
|
+ compatible = "gpio-keys-polled";
|
|
|
+ #address-cells = <1>;
|
|
|
+ #size-cells = <0>;
|
|
|
+ poll-interval = <20>;
|
|
|
+
|
|
|
+ reset {
|
|
|
+ label = "reset";
|
|
|
+ linux,code = <KEY_RESTART>;
|
|
|
+ gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
|
|
|
+ debounce-interval = <60>;
|
|
|
+ };
|
|
|
+
|
|
|
+ wps {
|
|
|
+ label = "wps";
|
|
|
+ linux,code = <KEY_WPS_BUTTON>;
|
|
|
+ gpios = <&gpio 26 GPIO_ACTIVE_HIGH>;
|
|
|
+ debounce-interval = <60>;
|
|
|
+ };
|
|
|
+ };
|
|
|
+
|
|
|
+ gpio-leds {
|
|
|
+ compatible = "gpio-leds";
|
|
|
+ pinctrl-names = "default";
|
|
|
+ pinctrl-0 = <&switch_led_pins>;
|
|
|
+
|
|
|
+ lan1 {
|
|
|
+ label = "tp-link:green:lan1";
|
|
|
+ gpios = <&gpio 14 GPIO_ACTIVE_HIGH>;
|
|
|
+ };
|
|
|
+
|
|
|
+ lan2 {
|
|
|
+ label = "tp-link:green:lan2";
|
|
|
+ gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
|
|
|
+ };
|
|
|
+
|
|
|
+ lan3 {
|
|
|
+ label = "tp-link:green:lan3";
|
|
|
+ gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
|
|
|
+ };
|
|
|
+
|
|
|
+ lan4 {
|
|
|
+ label = "tp-link:green:lan4";
|
|
|
+ gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
|
|
|
+ };
|
|
|
+
|
|
|
+ qss {
|
|
|
+ label = "tp-link:green:qss";
|
|
|
+ gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
|
|
|
+ };
|
|
|
+
|
|
|
+ led_system: system {
|
|
|
+ label = "tp-link:green:system";
|
|
|
+ gpios = <&gpio 27 GPIO_ACTIVE_HIGH>;
|
|
|
+ };
|
|
|
+
|
|
|
+ wan {
|
|
|
+ label = "tp-link:green:wan";
|
|
|
+ gpios = <&gpio 13 GPIO_ACTIVE_HIGH>;
|
|
|
+ };
|
|
|
+
|
|
|
+ wlan {
|
|
|
+ label = "tp-link:green:wlan";
|
|
|
+ gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
|
|
|
+ default-state = "off";
|
|
|
+ linux,default-trigger = "phy0tpt";
|
|
|
+ };
|
|
|
+ };
|
|
|
+};
|
|
|
+
|
|
|
+&spi {
|
|
|
+ status = "okay";
|
|
|
+ num-cs = <1>;
|
|
|
+
|
|
|
+ flash@0 {
|
|
|
+ #address-cells = <1>;
|
|
|
+ #size-cells = <1>;
|
|
|
+ compatible = "jedec,spi-nor";
|
|
|
+ reg = <0>;
|
|
|
+ spi-max-frequency = <25000000>;
|
|
|
+
|
|
|
+ partitions {
|
|
|
+ compatible = "fixed-partitions";
|
|
|
+ #address-cells = <1>;
|
|
|
+ #size-cells = <1>;
|
|
|
+
|
|
|
+ uboot: partition@0 {
|
|
|
+ reg = <0x0 0x20000>;
|
|
|
+ label = "u-boot";
|
|
|
+ read-only;
|
|
|
+ };
|
|
|
+
|
|
|
+ firmware: partition@20000 {
|
|
|
+ reg = <0x20000 0x3d0000>;
|
|
|
+ label = "firmware";
|
|
|
+ };
|
|
|
+
|
|
|
+ art: partition@3f0000 {
|
|
|
+ reg = <0x3f0000 0x10000>;
|
|
|
+ label = "art";
|
|
|
+ read-only;
|
|
|
+ };
|
|
|
+ };
|
|
|
+ };
|
|
|
+};
|
|
|
+
|
|
|
+&mdio0 {
|
|
|
+ status = "okay";
|
|
|
+
|
|
|
+ phy4: ethernet-phy@4 {
|
|
|
+ reg = <4>;
|
|
|
+ phy-mode = "mii";
|
|
|
+ };
|
|
|
+};
|
|
|
+
|
|
|
+ð0 {
|
|
|
+ status = "okay";
|
|
|
+
|
|
|
+ phy-handle = <&phy4>;
|
|
|
+
|
|
|
+ mtd-mac-address = <&uboot 0x1fc00>;
|
|
|
+ mtd-mac-address-increment = <1>;
|
|
|
+
|
|
|
+ gmac-config {
|
|
|
+ device = <&gmac>;
|
|
|
+
|
|
|
+ switch-phy-addr-swap = <1>;
|
|
|
+ switch-phy-swap = <1>;
|
|
|
+ };
|
|
|
+};
|
|
|
+
|
|
|
+ð1 {
|
|
|
+ status = "okay";
|
|
|
+
|
|
|
+ mtd-mac-address = <&uboot 0x1fc00>;
|
|
|
+ mtd-mac-address-increment = <(-1)>;
|
|
|
+
|
|
|
+ fixed-link {
|
|
|
+ speed = <1000>;
|
|
|
+ full-duplex;
|
|
|
+ };
|
|
|
+};
|
|
|
+
|
|
|
+&gpio {
|
|
|
+ status = "okay";
|
|
|
+};
|
|
|
+
|
|
|
+&uart {
|
|
|
+ status = "okay";
|
|
|
+};
|
|
|
+
|
|
|
+&wmac {
|
|
|
+ status = "okay";
|
|
|
+ mtd-cal-data = <&art 0x1000>;
|
|
|
+ mtd-mac-address = <&uboot 0x1fc00>;
|
|
|
+};
|