ath79: fix RS-485 on Teltonika RUT-955

DTR GPIO isn't actually needed and triggers boot warning.
TX pin was off by one (GPIO 19 instead of GPIO 18).

Reported-by: @tophirsch
Fixes: d1130ad265 ("ath79: add support for Teltonika RUT955")
Signed-off-by: Daniel Golle <[email protected]>

target/linux/ath79/dts/ar9344_teltonika_rut955-h7v3c0.dts

@@ -159,10 +159,6 @@
 	};
 };
 
-&hs_uart {
-	dtr-gpios = <&gpio_ext 15 GPIO_ACTIVE_HIGH>;
-};
-
 &eth0 {
 	status = "okay";
 

target/linux/ath79/dts/ar9344_teltonika_rut955.dts

@@ -158,10 +158,6 @@
 	};
 };
 
-&hs_uart {
-	dtr-gpios = <&gpio_ext 13 GPIO_ACTIVE_HIGH>;
-};
-
 &eth0 {
 	status = "okay";
 

target/linux/ath79/dts/ar9344_teltonika_rut9xx.dtsi

@@ -154,20 +154,20 @@
 &pinmux {
 	pmx_spi: spi {
 		// SPI_CS1 on GPIO 3
-		pinctrl-single,bits = <0x0 0x07000000 0xff000000>;
+		pinctrl-single,bits =	<0x0 0x07000000 0xff000000>;
 	};
 
 	pmx_leds_switch: leds_switch {
 		// switch port LEDs on GPIO 1, GPIO 13, GPIO 14 and GPIO 22
-		pinctrl-single,bits =  <0x0 0x00002d00 0x0000ff00>,
-					<0xc 0x002c2b00 0x00ffff00>,
+		pinctrl-single,bits =	<0x00 0x00002d00 0x0000ff00>,
+					<0x0c 0x002c2b00 0x00ffff00>,
 					<0x14 0x002a0000 0x00ff0000>;
 	};
 
 	pmx_uart2: uart2 {
 		// UART1_DTR on GPIO 0, UART1_RD on GPIO 11, UART1_TD on GPIO 18
-		pinctrl-single,bits = <0x0 0x0 0xff>,
-				<0x10 0x4f000000 0xff000000>,
-				<0x3c 0x000b0000 0x00ff0000>;
+		pinctrl-single,bits =	<0x00 0x00000000 0x000000ff>,
+					<0x10 0x004f0000 0x00ff0000>,
+					<0x3c 0x000b0000 0x00ff0000>;
 	};
 };