ramips: add support for ELECOM WMC-S1267GS2

ELECOM WMC-S1267GS2 is a 2.4/5 GHz band 11ac (Wi-Fi 5) mesh extender,
based on MT7621A.

This device has almost the same hardware as WMC-M1267GST2.

Specification:

- SoC          : MediaTek MT7621A
- RAM          : DDR3 256 MiB (Nanya NT5CC128M16JR-EK)
- Flash        : SPI-NOR 32 MiB (Winbond W25Q256JVFIQ)
- WLAN         : 2.4/5 GHz 2T2R (MediaTek MT7615D)
- Ethernet     : 10/100/1000 Mbps x4
  - switch     : MediaTek MT7530 (SoC)
- LEDs/Keys    : 6x/6x
- UART         : through-hole on PCB ("J4")
  - arrangement: 3.3V, GND, TX, RX from tri-angle marking
  - settings   : 57600n8
- Power        : 12 VDC, 1 A

Flash instruction using factory image:

1. Boot WMC-S1267GS2 normally
2. Set IP address of the computer to 192.168.2.x
3. Access to "http://192.168.2.1/" and open firmware update page
   ("ファームウェア更新")
4. Select the OpenWrt factory image and click apply ("適用") button
5. Wait ~120 seconds to complete flashing

MAC addresses:

LAN    : 04:AB:18:xx:xx:9E (Factory, 0xFFF4 (hex))
2.4 GHz: 04:AB:18:xx:xx:9F
5 GHz  : 04:AB:18:xx:xx:A0 (Factory, 0x4 (hex))

Signed-off-by: INAGAKI Hiroshi <[email protected]>

target/linux/ramips/dts/mt7621_elecom_wmc-s1267gs2.dts

@@ -0,0 +1,82 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "mt7621_elecom_wrc-gs-1pci.dtsi"
+
+/ {
+	compatible = "elecom,wmc-s1267gs2", "mediatek,mt7621-soc";
+	model = "ELECOM WMC-S1267GS2";
+
+	aliases {
+		/*
+		 * A MAC address printed to the label is an address of
+		 * 5 GHz band on stock firmware, but there is no
+		 * per-band MAC address support on Linux Kernel and that
+		 * address is not assigned to any wlan devices now.
+		 */
+		/delete-property/ label-mac-device;
+	};
+};
+
+&gmac0 {
+	nvmem-cells = <&macaddr_factory_fff4>;
+	nvmem-cell-names = "mac-address";
+};
+
+&gmac1 {
+	status = "disabled";
+};
+
+&partitions {
+	partition@50000 {
+		compatible = "denx,uimage";
+		label = "firmware";
+		reg = <0x50000 0x1800000>;
+	};
+
+	partition@1850000 {
+		label = "tm_pattern";
+		reg = <0x1850000 0x400000>;
+		read-only;
+	};
+
+	partition@1c50000 {
+		label = "tm_key";
+		reg = <0x1c50000 0x100000>;
+		read-only;
+	};
+
+	partition@1d50000 {
+		label = "nvram";
+		reg = <0x1d50000 0xb0000>;
+		read-only;
+	};
+
+	partition@1e00000 {
+		label = "user_data";
+		reg = <0x1e00000 0x200000>;
+		read-only;
+	};
+};
+
+&wifi {
+	nvmem-cells = <&macaddr_factory_4 (-1)>;
+	nvmem-cell-names = "mac-address";
+};
+
+&factory {
+	nvmem-layout {
+		compatible = "fixed-layout";
+		#address-cells = <1>;
+		#size-cells = <1>;
+
+		macaddr_factory_4: macaddr@4 {
+			compatible = "mac-base";
+			reg = <0x4 0x6>;
+			#nvmem-cell-cells = <1>;
+		};
+
+		macaddr_factory_fff4: macaddr@fff4 {
+			reg = <0xfff4 0x6>;
+		};
+	};
+};

target/linux/ramips/image/mt7621.mk

@@ -998,6 +998,14 @@ define Device/elecom_wmc-m1267gst2
 endef
 TARGET_DEVICES += elecom_wmc-m1267gst2
 
+define Device/elecom_wmc-s1267gs2
+  $(Device/elecom_wrc-gs)
+  IMAGE_SIZE := 24576k
+  DEVICE_MODEL := WMC-S1267GS2
+  ELECOM_HWNAME := WMC-DLGST2
+endef
+TARGET_DEVICES += elecom_wmc-s1267gs2
+
 define Device/elecom_wrc-1167ghbk2-s
   $(Device/dsa-migration)
   IMAGE_SIZE := 15488k

target/linux/ramips/mt7621/base-files/etc/board.d/02_network

@@ -102,17 +102,18 @@ ramips_setup_interfaces()
 	dlink,covr-x1860-a1)
 		ucidef_set_interfaces_lan_wan "ethernet" "internet"
 		;;
+	elecom,wmc-s1267gs2|\
+	linksys,re6500|\
+	netgear,wac104|\
+	zyxel,lte3301-plus)
+		ucidef_set_interface_lan "lan1 lan2 lan3 lan4"
+		;;
 	gnubee,gb-pc1)
 		ucidef_set_interface_lan "ethblack ethblue"
 		;;
 	gnubee,gb-pc2)
 		ucidef_set_interface_lan "ethblack ethblue ethyellow"
 		;;
-	linksys,re6500|\
-	netgear,wac104|\
-	zyxel,lte3301-plus)
-		ucidef_set_interface_lan "lan1 lan2 lan3 lan4"
-		;;
 	mikrotik,routerboard-750gr3)
 		ucidef_set_interfaces_lan_wan "lan2 lan3 lan4 lan5" "wan"
 		;;