ramips: Remove LED GPIO definitions in MQmaker WiTi device tree

LED's were defined wrong in the device tree file, they are hardware driven because they are connected directly to the switch chip and wireless chips respectively, thus no GPIO addresses are assigned to them. It is safe to remove them from the device tree file to stop confusion.

Signed-off-by: Sebastian Careba <[email protected]>

SVN-Revision: 48055

target/linux/ramips/dts/WITI.dts

@@ -104,25 +104,6 @@
 		mtd-mac-address = <&factory 0xe000>;
 	};
 
-	gpio-leds {
-		compatible = "gpio-leds";
-
-		power {
-			label = "witi:green:power";
-			gpios = <&gpio0 25 1>;
-		};
-
-		sys {
-			label = "witi:green:sys";
-			gpios = <&gpio0 24 1>;
-		};
-
-		internet {
-			label = "witi:green:internet";
-			gpios = <&gpio0 23 1>;
-		};
-	};
-
 	gpio-keys-polled {
 		compatible = "gpio-keys-polled";
 		#address-cells = <1>;