generic: ar8216: start AR8327 switch from the probe routine

The AR8327 switch gets its configuration from platform
data or from the device-tree. This allows to start it
from the probe routine. Doing so makes it usable with
ethernet drivers which only connects to the PHY device
when the ethernet interface is opened.

Signed-off-by: Gabor Juhos <[email protected]>

SVN-Revision: 36050

target/linux/generic/files/drivers/net/phy/ar8216.c

@@ -1945,6 +1945,9 @@ ar8xxx_phy_config_init(struct phy_device *phydev)
 	if (WARN_ON(!priv))
 		return -ENODEV;
 
+	if (chip_is_ar8327(priv))
+		return 0;
+
 	priv->phy = phydev;
 
 	if (phydev->addr != 0) {
@@ -2103,6 +2106,8 @@ ar8xxx_phy_probe(struct phy_device *phydev)
 		swdev->devname, swdev->name, dev_name(&priv->mii_bus->dev));
 
 found:
+	priv->use_count++;
+
 	if (phydev->addr == 0) {
 		if (ar8xxx_has_gige(priv)) {
 			phydev->supported = SUPPORTED_1000baseT_Full;
@@ -2111,6 +2116,14 @@ found:
 			phydev->supported = SUPPORTED_100baseT_Full;
 			phydev->advertising = ADVERTISED_100baseT_Full;
 		}
+
+		if (chip_is_ar8327(priv)) {
+			priv->phy = phydev;
+
+			ret = ar8xxx_start(priv);
+			if (ret)
+				goto err_unregister_switch;
+		}
 	} else {
 		if (ar8xxx_has_gige(priv)) {
 			phydev->supported |= SUPPORTED_1000baseT_Full;
@@ -2119,7 +2132,6 @@ found:
 	}
 
 	phydev->priv = priv;
-	priv->use_count++;
 
 	list_add(&priv->list, &ar8xxx_dev_list);
 
@@ -2127,6 +2139,12 @@ found:
 
 	return 0;
 
+err_unregister_switch:
+	if (--priv->use_count)
+		goto unlock;
+
+	unregister_switch(&priv->dev);
+
 free_priv:
 	ar8xxx_free(priv);
 unlock: