qualcommax: add missing WAN LED support to Spectrum SAX1V1K routers

Fixed an issue where both WAN LEDs light up before plugging in the
ethernet cable and no blinking regardless of WAN network activity.

Updated the LED configuration to reflect proper status:
Green indicates 2.5Gb connection speed.
Yellow indicates other connection speed and traffic activity.

This resolves inconsistent WAN LED behavior on Spectrum SAX1V1K routers.

Signed-off-by: Ivan Deng <[email protected]>
Link: https://github.com/openwrt/openwrt/pull/17623
Signed-off-by: Robert Marko <[email protected]>

target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq8072-sax1v1k.dts

@@ -137,6 +137,27 @@
 		reg = <28>;
 		reset-gpios = <&tlmm 44 GPIO_ACTIVE_LOW>;
 		reset-deassert-us = <10000>;
+		
+		leds {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			led@0 {
+				reg = <0>;
+				color = <LED_COLOR_ID_YELLOW>;
+				function = LED_FUNCTION_WAN;
+				default-state = "keep";
+				active-low;
+			};
+
+			led@2 {
+				reg = <2>;
+				color = <LED_COLOR_ID_GREEN>;
+				function = LED_FUNCTION_WAN;
+				default-state = "keep";
+				active-low;
+			};
+		};
 	};
 };
 

target/linux/qualcommax/ipq807x/base-files/etc/board.d/01_leds

@@ -16,7 +16,8 @@ asus,rt-ax89x)
 	ucidef_set_led_netdev "sfp" "SFP" "white:sfp" "10g-sfp"
 	ucidef_set_led_netdev "wan" "WAN" "white:wan" "wan"
 	;;
-dynalink,dl-wrx36)
+dynalink,dl-wrx36|\
+spectrum,sax1v1k)
 	ucidef_set_led_netdev "wan-port-link-green" "WAN-PORT-LINK-GREEN" "90000.mdio-1:1c:green:wan" "wan" "link_2500"
 	ucidef_set_led_netdev "wan-port-link-yellow" "WAN-PORT-LINK-YELLOW" "90000.mdio-1:1c:yellow:wan" "wan" "tx rx link_10 link_100 link_1000"
 	;;