mpc85xx: overhaul WS-AP3825i LED setup

As the LED controller is working now, we can make good use of the LEDs
now.

 - Drop the model-name prefix
 - Rename eth0 / eth1 LEDs to LAN1 / LAN2, as they are labeled as such
   on the casing
 - Enable wired LEDs in userspace

Signed-off-by: David Bauer <[email protected]>

target/linux/mpc85xx/base-files/etc/board.d/01_leds

@@ -0,0 +1,19 @@
+
+. /lib/functions/leds.sh
+. /lib/functions/uci-defaults.sh
+
+board=$(board_name)
+boardname="${board##*,}"
+
+board_config_update
+
+case $board in
+extreme-networks,ws-ap3825i)
+	ucidef_set_led_netdev "lan1" "LAN1" "green:lan1" "eth1"
+	ucidef_set_led_netdev "lan2" "LAN2" "green:lan2" "eth0"
+	;;
+esac
+
+board_config_flush
+
+exit 0

target/linux/mpc85xx/files/arch/powerpc/boot/dts/ws-ap3825i.dts

@@ -31,44 +31,44 @@
 
 		wifi1 {
 			gpios = <&spi_gpio 3 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:green:radio1";
+			label = "green:radio1";
 			linux,default-trigger = "phy0tpt";
 		};
 
 		wifi2 {
 			gpios = <&spi_gpio 2 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:green:radio2";
+			label = "green:radio2";
 			linux,default-trigger = "phy1tpt";
 		};
 
 		led_power_green: power_green {
 			gpios = <&spi_gpio 0 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:green:power";
+			label = "green:power";
 		};
 
 		led_power_red: power_red {
 			gpios = <&spi_gpio 1 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:red:power";
+			label = "red:power";
 		};
 
-		eth0_red {
+		lan1_red {
 			gpios = <&spi_gpio 6 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:red:eth0";
+			label = "red:lan1";
 		};
 
-		eth0_green {
+		lan1_green {
 			gpios = <&spi_gpio 4 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:green:eth0";
+			label = "green:lan1";
 		};
 
-		eth1_red {
+		lan2_red {
 			gpios = <&spi_gpio 7 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:red:eth1";
+			label = "red:lan2";
 		};
 
-		eth1_green {
+		lan2_green {
 			gpios = <&spi_gpio 5 GPIO_ACTIVE_HIGH>;
-			label = "ws-ap3825i:green:eth1";
+			label = "green:lan2";
 		};
 	};