ath79: add support for TP-Link Archer c7 v2

Signed-off-by: Sibren Vasse <[email protected]>

target/linux/ath79/base-files/etc/board.d/02_network

@@ -40,6 +40,12 @@ ath79_setup_interfaces()
 		"0@eth1" "1:lan" "2:lan" "3:lan:3" "4:lan:4"
 		;;
 
+	"tplink,tl-archer-c7-v2")
+		ucidef_set_interfaces_lan_wan "eth1.1" "eth0.2"
+		ucidef_add_switch "switch0" \
+			"0@eth1" "2:lan" "3:lan" "4:lan" "5:lan" "6@eth0" "1:wan"
+		;;
+
 	"tplink,tl-mr3020-v1")
 		ucidef_set_interface_lan "eth0.1"
 		ucidef_add_switch "switch0" "0@eth0" "1:lan"

target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata

@@ -87,10 +87,14 @@ board=$(board_name)
 case "$FIRMWARE" in
 "ath10k/cal-pci-0000:00:00.0.bin")
 	case $board in
-	openmesh,om5p-ac-v2)
+	"openmesh,om5p-ac-v2")
 		ath10kcal_extract "ART" 20480 2116
 		ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) +16)
 		;;
+	"tplink,tl-archer-c7-v2")
+		ath10kcal_extract "art" 20480 2116
+		ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth1/address) -2)
+		;;
 	"ubnt,ubnt-unifiac-lite")
 		ath10kcal_extract "EEPROM" 20480 2116
 		;;

target/linux/ath79/dts/qca9558_tl-archer-c7-v2.dts

@@ -0,0 +1,16 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca9558_tl-archer-c7.dtsi"
+
+/ {
+	compatible = "tplink,tl-archer-c7-v2", "qca,qca9558";
+	model = "TP-Link Archer C7 Version 2";
+};
+
+&rfkill {
+	gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
+};

target/linux/ath79/dts/qca9558_tl-archer-c7.dtsi

@@ -0,0 +1,232 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca9557.dtsi"
+
+/ {
+	memory@0 {
+		device_type = "memory";
+		reg = <0x0 0x8000000>;
+	};
+
+	chosen {
+		bootargs = "console=ttyS0,115200n8";
+	};
+
+	aliases {
+		led-status = &system;
+	};
+
+	leds {
+		compatible = "gpio-leds";
+
+		system: system {
+			label = "tp-link:green:system";
+			gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+			default-state = "on";
+		};
+
+		usb1 {
+			label = "tp-link:green:usb1";
+			gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
+			default-state = "off";
+			trigger-sources = <&hub_port0>;
+			linux,default-trigger = "usbport";
+		};
+
+		usb2 {
+			label = "tp-link:green:usb2";
+			gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
+			default-state = "off";
+			trigger-sources = <&hub_port1>;
+			linux,default-trigger = "usbport";
+		};
+
+		wlan2g {
+			label = "tp-link:green:wlan2g";
+			gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+			default-state = "off";
+			linux,default-trigger = "phy1tpt";
+		};
+
+		qss {
+			label = "tp-link:green:qss";
+			gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+			default-state = "off";
+		};
+
+		wlan5g {
+			label = "tp-link:green:wlan5g";
+			gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+			default-state = "off";
+			linux,default-trigger = "phy0tpt";
+		};
+	};
+
+	keys {
+		compatible = "gpio-keys";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		reset {
+			label = "Reset button";
+			linux,code = <KEY_RESTART>;
+			gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+			debounce-interval = <60>;
+		};
+
+		rfkill: wifi {
+			linux,code = <KEY_RFKILL>;
+			linux,input-type = <EV_SW>;
+			debounce-interval = <60>;
+		};
+	};
+
+	gpio-export {
+		compatible = "gpio-export";
+		#size-cells = <0>;
+
+		gpio_usb1_power {
+			gpio-export,name = "tp-link:power:usb1";
+			gpio-export,output = <1>;
+			gpios = <&gpio 22 GPIO_ACTIVE_HIGH>;
+		};
+
+		gpio_usb2_power {
+			gpio-export,name = "tp-link:power:usb2";
+			gpio-export,output = <1>;
+			gpios = <&gpio 21 GPIO_ACTIVE_HIGH>;
+		};
+
+	};
+};
+
+&pcie1 {
+	status = "okay";
+};
+
+&uart {
+	status = "okay";
+};
+
+&gpio {
+	status = "okay";
+};
+
+&usb_phy0 {
+	status = "okay";
+};
+
+&usb0 {
+	status = "okay";
+
+	hub_port0: port@1 {
+		reg = <1>;
+		#trigger-source-cells = <0>;
+	};
+};
+
+&usb_phy1 {
+	status = "okay";
+};
+
+&usb1 {
+	status = "okay";
+
+	hub_port1: port@1 {
+		reg = <1>;
+		#trigger-source-cells = <0>;
+	};
+};
+
+&spi {
+	status = "okay";
+	num-cs = <1>;
+
+	flash@0 {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <25000000>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			uboot: partition@0 {
+				label = "u-boot";
+				reg = <0x000000 0x020000>;
+				read-only;
+			};
+
+			partition@20000 {
+				label = "firmware";
+				reg = <0x020000 0xfd0000>;
+			};
+
+			art: partition@ff0000 {
+				label = "art";
+				reg = <0xff0000 0x010000>;
+				read-only;
+			};
+		};
+	};
+};
+
+&mdio0 {
+	status = "okay";
+
+	phy0: ethernet-phy@0 {
+		reg = <0>;
+
+		qca,ar8327-initvals = <
+			0x04 0x00080080 /* PORT0 PAD MODE CTRL */
+			0x0c 0x07600000 /* PORT6 PAD MODE CTRL */
+			0x50 0xc737c737 /* LED_CTRL0 */
+			0x54 0x00000000 /* LED_CTRL1 */
+			0x58 0x00000000 /* LED_CTRL2 */
+			0x5c 0x0030c300 /* LED_CTRL3 */
+			0x7c 0x0000007e /* PORT0_STATUS */
+			0x94 0x0000007e /* PORT6 STATUS */
+			>;
+	};
+};
+
+&mdio1 {
+	status = "okay";
+
+	phy1: ethernet-phy@1 {
+		reg = <1>;
+	};
+};
+
+&eth0 {
+	status = "okay";
+
+	mtd-mac-address = <&uboot 0x1fc00>;
+	mtd-mac-address-increment = <1>;
+	phy-handle = <&phy0>;
+};
+
+&eth1 {
+	status = "okay";
+
+	mtd-mac-address = <&uboot 0x1fc00>;
+	phy-handle = <&phy1>;
+
+	fixed-link {
+		speed = <1000>;
+		full-duplex;
+	};
+};
+
+&wmac {
+	status = "okay";
+	mtd-cal-data = <&art 0x1000>;
+	mtd-mac-address = <&uboot 0x1fc00>;
+};

target/linux/ath79/image/common-tp-link.mk

@@ -82,3 +82,9 @@ $(Device/tplink)
   TPLINK_FLASHLAYOUT := 8Mlzma
   IMAGE_SIZE := 7936k
 endef
+
+define Device/tplink-16mlzma
+  $(Device/tplink)
+  TPLINK_FLASHLAYOUT := 16Mlzma
+  IMAGE_SIZE := 15872k
+endef

target/linux/ath79/image/generic-tp-link.mk

@@ -1,5 +1,18 @@
 include ./common-tp-link.mk
 
+define Device/tl-archer-c7-v2
+  $(Device/tplink-16mlzma)
+  ATH_SOC := qca9558
+  DEVICE_TITLE := TP-LINK Archer C7 v2
+  DEVICE_PACKAGES := kmod-usb-core kmod-usb2 kmod-usb-ledtrig-usbport kmod-ath10k ath10k-firmware-qca988x
+  TPLINK_HWID := 0xc7000002
+  SUPPORTED_DEVICES := tplink,tl-archer-c7-v2
+  IMAGES := sysupgrade.bin factory.bin factory-us.bin factory-eu.bin
+  IMAGE/factory-us.bin := append-rootfs | mktplinkfw factory -C US
+  IMAGE/factory-eu.bin := append-rootfs | mktplinkfw factory -C EU
+endef
+TARGET_DEVICES += tl-archer-c7-v2
+
 define Device/tl-wdr3600
   $(Device/tplink-8mlzma)
   ATH_SOC := ar9344