ath79: araknis_an-300-ap-i-n: use led-sources

The ath9k driver creates an ath9k LED by default. Instead of having a
non functional LED, configure it properly and remove the extra as it's
not needed.

Signed-off-by: Rosen Penev <[email protected]>
Link: https://github.com/openwrt/openwrt/pull/18904
Signed-off-by: Robert Marko <[email protected]>

target/linux/ath79/dts/ar9344_araknis_an-300-ap-i-n.dts

@@ -38,28 +38,12 @@
 			default-state = "off";
 		};
 
-		wifi5g {
-			label = "blue:wifi5g";
-			gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
-			linux,default-trigger = "phy0tpt";
-		};
-
 		wps {
 			function = LED_FUNCTION_WPS;
 			color = <LED_COLOR_ID_BLUE>;
 			gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
 		};
 	};
-
-	ath9k-leds {
-		compatible = "gpio-leds";
-
-		wifi2g {
-			label = "blue:wifi2g";
-			gpios = <&ath9k 0 GPIO_ACTIVE_LOW>;
-			linux,default-trigger = "phy1tpt";
-		};
-	};
 };
 
 &mdio0 {
@@ -87,14 +71,17 @@
 &pcie {
 	status = "okay";
 
-	ath9k: wifi@0,0 {
+	wifi@0,0 {
 		compatible = "pci168c,0030";
 		reg = <0x0 0 0 0 0>;
 		nvmem-cells = <&macaddr_art_0 1>, <&calibration_art_5000>;
 		nvmem-cell-names = "mac-address", "calibration";
 		ieee80211-freq-limit = <2402000 2482000>;
-		#gpio-cells = <2>;
-		gpio-controller;
+
+		led {
+			led-sources = <0>;
+			led-active-low;
+		};
 	};
 };
 
@@ -105,6 +92,11 @@
 
 	nvmem-cells = <&macaddr_art_0 2>, <&calibration_art_1000>;
 	nvmem-cell-names = "mac-address", "calibration";
+
+	led {
+		led-sources = <12>;
+		led-active-low;
+	};
 };
 
 &art {