qualcommax: enable PHYLIB LED support

CONFIG_PHYLIB_LEDS is required in order for phylib to probe the DT for LEDs
attached to PHY-s.

Fixes: 75ad5c2 ("qualcommax: switch to qca8081 upstream PHY driver")
Signed-off-by: Robert Marko <[email protected]>

target/linux/qualcommax/config-6.1

@@ -274,6 +274,7 @@ CONFIG_NO_HZ_IDLE=y
 CONFIG_NR_CPUS=4
 CONFIG_NVIDIA_CARMEL_CNP_ERRATUM=y
 CONFIG_NVMEM=y
+CONFIG_NVMEM_LAYOUTS=y
 CONFIG_NVMEM_QCOM_QFPROM=y
 # CONFIG_NVMEM_QCOM_SEC_QFPROM is not set
 CONFIG_NVMEM_SYSFS=y
@@ -290,6 +291,7 @@ CONFIG_PADATA=y
 CONFIG_PAGE_POOL=y
 CONFIG_PAGE_SIZE_LESS_THAN_256KB=y
 CONFIG_PAGE_SIZE_LESS_THAN_64KB=y
+CONFIG_PAHOLE_HAS_LANG_EXCLUDE=y
 CONFIG_PARTITION_PERCPU=y
 CONFIG_PCI=y
 CONFIG_PCIEAER=y
@@ -309,6 +311,7 @@ CONFIG_PCI_MSI=y
 CONFIG_PCI_MSI_IRQ_DOMAIN=y
 CONFIG_PGTABLE_LEVELS=3
 CONFIG_PHYLIB=y
+CONFIG_PHYLIB_LEDS=y
 CONFIG_PHYS_ADDR_T_64BIT=y
 # CONFIG_PHY_QCOM_APQ8064_SATA is not set
 # CONFIG_PHY_QCOM_EDP is not set
@@ -376,6 +379,7 @@ CONFIG_QCOM_BAM_DMA=y
 # CONFIG_QCOM_LLCC is not set
 CONFIG_QCOM_MDT_LOADER=y
 # CONFIG_QCOM_MPM is not set
+CONFIG_QCOM_NET_PHYLIB=y
 # CONFIG_QCOM_OCMEM is not set
 # CONFIG_QCOM_PDC is not set
 CONFIG_QCOM_PIL_INFO=y