ipq40xx: convert EZVIZ CS-W3-WD1200G-EUP to DSA

Convert the repeater to DSA.

Signed-off-by: Christian Lamparter <[email protected]>

target/linux/ipq40xx/base-files/etc/board.d/02_network

@@ -82,6 +82,7 @@ ipq40xx_setup_interfaces()
 		ucidef_set_interface_lan "sw-eth1 sw-eth2"
 		;;
 	aruba,ap-303h|\
+	ezviz,cs-w3-wd1200g-eup|\
 	netgear,rbr50|\
 	netgear,rbs50|\
 	netgear,srr60|\

target/linux/ipq40xx/files/arch/arm/boot/dts/qcom-ipq4018-cs-w3-wd1200g-eup.dts

@@ -239,6 +239,42 @@
 	status = "okay";
 };
 
+&gmac {
+	status = "okay";
+	nvmem-cells = <&macaddr_art_0>;
+	nvmem-cell-names = "mac-address";
+};
+
+&switch {
+	status = "okay";
+};
+
+&swport2 {
+	status = "okay";
+	label = "lan3";
+};
+
+&swport3 {
+	status = "okay";
+	label = "lan2";
+};
+
+&swport4 {
+	status = "okay";
+	label = "lan1";
+};
+
+&swport5 {
+	status = "okay";
+	label = "wan";
+	nvmem-cells = <&macaddr_art_6>;
+	nvmem-cell-names = "mac-address";
+};
+
+&ethphy0 {
+	status = "disabled";
+};
+
 &wifi0 {
 	status = "okay";
 	qcom,ath10k-calibration-variant = "ezviz-cs-w3-wd1200g-eup";

target/linux/ipq40xx/image/generic.mk

@@ -555,8 +555,7 @@ define Device/ezviz_cs-w3-wd1200g-eup
 	DEVICE_COMPAT_MESSAGE := uboot's bootcmd has to be updated (see wiki). \
 		Upgrade via sysupgrade mechanism is not possible.
 endef
-# Missing DSA Setup
-#TARGET_DEVICES += ezviz_cs-w3-wd1200g-eup
+TARGET_DEVICES += ezviz_cs-w3-wd1200g-eup
 
 define Device/glinet_gl-a1300
 	$(call Device/FitImage)