qualcommax: AW1000: add qca8081 PHY LED configuration

Since we can configure the PHY LED of the qca8081,
add a configuration for this device.

Signed-off-by: Chukun Pan <[email protected]>
Reviewed-by: Robert Marko <[email protected]>

target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq8072-aw1000.dts

@@ -280,6 +280,19 @@
 		reg = <28>;
 		reset-deassert-us = <10000>;
 		reset-gpios = <&tlmm 64 GPIO_ACTIVE_LOW>;
+
+		leds {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			led@2 {
+				reg = <2>;
+				active-low;
+				color = <LED_COLOR_ID_GREEN>;
+				function = LED_FUNCTION_WAN;
+				default-state = "keep";
+			};
+		};
 	};
 };
 

target/linux/qualcommax/ipq807x/base-files/etc/board.d/01_leds

@@ -9,6 +9,7 @@ case "$board" in
 arcadyan,aw1000)
 	ucidef_set_led_netdev "5g" "5G" "green:5g" "wwan0"
 	ucidef_set_led_netdev "wan" "WAN" "green:internet" "wan"
+	ucidef_set_led_netdev "wan-port-link" "WAN-PORT-LINK" "90000.mdio-1:1c:green:wan" "wan" "tx rx link_10 link_100 link_1000 link_2500"
 	;;
 dynalink,dl-wrx36)
 	ucidef_set_led_netdev "wan-port-link-green" "WAN-PORT-LINK-GREEN" "90000.mdio-1:1c:green:wan" "wan" "link_2500"