Просмотр исходного кода

ipq40xx: meraki: define DTB load address

It seems that the Meraki bootloader does not respect the kernel ARM booting
specification[1] that requires that address where DTB is located needs to
be 64-bit aligned and often places the DTB on a non 64-bit aligned address
and then kernel fails to find the DTB magic and fails to boot.
Even worse, there is no prints until early printk is enabled and then its
visible that kernel is trying to find the ATAG-s as DTB was not found or
is invalid.

Unifi 6 devices had the same issue and it can be solved by passing the
load adress as part of the FIT image.
It seems that the vendor was aware of the issue and is always relocating
the DTB to 0x89000000, so lets just do the same.

Now that booting is reliable, reenable default images for the Meraki MR33
and MR74 devices.

Reviewed-by: Lech Perczak [email protected]
Signed-off-by: Robert Marko <[email protected]>
Robert Marko 2 лет назад
Родитель
Сommit
f1c80445bd
1 измененных файлов с 1 добавлено и 2 удалено
  1. 1 2
      target/linux/ipq40xx/image/generic.mk

+ 1 - 2
target/linux/ipq40xx/image/generic.mk

@@ -762,13 +762,13 @@ define Device/meraki_common
 	SOC := qcom-ipq4029
 	BLOCKSIZE := 128k
 	PAGESIZE := 2048
+	DEVICE_DTS_LOADADDR := 0x89000000
 	DEVICE_PACKAGES := ath10k-firmware-qca9887-ct
 endef
 
 define Device/meraki_mr33
 	$(call Device/meraki_common)
 	DEVICE_MODEL := MR33
-	DEFAULT := n
 endef
 TARGET_DEVICES += meraki_mr33
 
@@ -776,7 +776,6 @@ define Device/meraki_mr74
 	$(call Device/meraki_common)
 	DEVICE_MODEL := MR74
 	DEVICE_DTS_CONFIG := config@3
-	DEFAULT := n
 endef
 TARGET_DEVICES += meraki_mr74