ath79: gmac: add parsers for rxd(v)- and tx(d|en)-delay for AR9344

Some AR9344 boards do very poorly with the default settings and
need custom rxdv-delay, rxd-delay, txd-delay, txen-delay flags
to perform reasonably.

In this case the WD My Net Wi-Fi Range Extender can not even
manage 10Mbps on a 1Gbit link:

root@AR9344:~# iperf3 -s
-----------------------------------------------------------
Server listening on 5201
-----------------------------------------------------------
Accepted connection from client [...]
[  5] local [...] connected to client
[ ID] Interval           Transfer     Bitrate
[  5]   0.00-1.00   sec  1.09 MBytes  9.16 Mbits/sec
[  5]   1.00-2.00   sec   895 KBytes  7.33 Mbits/sec
[  5]   2.00-3.00   sec   762 KBytes  6.25 Mbits/sec
[...]
[  5]  10.00-10.03  sec  17.0 KBytes  4.74 Mbits/sec
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval           Transfer     Bitrate
[  5]   0.00-10.03  sec  9.00 MBytes  7.52 Mbits/sec

with but with the correct settings in place, it does much better:

root@AR9344:~# iperf3 -s
-----------------------------------------------------------
Server listening on 5201
-----------------------------------------------------------
Accepted connection from client [...]
[  5] local [...] connected to client
[ ID] Interval           Transfer     Bitrate
[  5]   0.00-1.00   sec  23.1 MBytes   193 Mbits/sec
[  5]   1.00-2.00   sec  23.1 MBytes   194 Mbits/sec
[  5]   2.00-3.00   sec  23.2 MBytes   195 Mbits/sec
[...]
[  5]  10.00-10.04  sec   710 KBytes   180 Mbits/sec
- - - - - - - - - - - - - - - - - - - - - - - - -
[ ID] Interval           Transfer     Bitrate
[  5]   0.00-10.04  sec   237 MBytes   198 Mbits/sec

The tx data and enable delay bits definitions are taken from Atheros'
AR9344 Data Sheet Section "8.6.1 Ethernet Configuration (ETH_CFG)" on
page 153.

Signed-off-by: Christian Lamparter <[email protected]>

target/linux/ath79/files/drivers/net/ethernet/atheros/ag71xx/ag71xx_gmac.c

@@ -57,6 +57,14 @@ static void ag71xx_setup_gmac_934x(struct device_node *np, void __iomem *base)
 	ag71xx_of_bit(np, "switch-phy-swap", &val, AR934X_ETH_CFG_SW_PHY_SWAP);
 	ag71xx_of_bit(np, "switch-only-mode", &val,
 		AR934X_ETH_CFG_SW_ONLY_MODE);
+	ag71xx_of_set(np, "rxdv-delay", &val,
+		      AR934X_ETH_CFG_RDV_DELAY_SHIFT, 0x3);
+	ag71xx_of_set(np, "rxd-delay", &val,
+		      AR934X_ETH_CFG_RXD_DELAY_SHIFT, 0x3);
+	ag71xx_of_set(np, "txd-delay", &val,
+		      AR934X_ETH_CFG_TXD_DELAY_SHIFT, 0x3);
+	ag71xx_of_set(np, "txen-delay", &val,
+		      AR934X_ETH_CFG_TXE_DELAY_SHIFT, 0x3);
 
 	__raw_writel(val, base + AR934X_GMAC_REG_ETH_CFG);
 }

target/linux/ath79/patches-4.14/0009-MIPS-ath79-add-lots-of-missing-registers.patch

@@ -650,7 +650,7 @@ Signed-off-by: John Crispin <[email protected]>
  
  /*
   * SRIF block
-@@ -552,4 +1007,318 @@
+@@ -552,4 +1007,322 @@
  #define AR934X_SRIF_DPLL2_OUTDIV_SHIFT	13
  #define AR934X_SRIF_DPLL2_OUTDIV_MASK	0x7
  
@@ -876,6 +876,10 @@ Signed-off-by: John Crispin <[email protected]>
 +#define AR934X_ETH_CFG_RDV_DELAY        BIT(16)
 +#define AR934X_ETH_CFG_RDV_DELAY_MASK   0x3
 +#define AR934X_ETH_CFG_RDV_DELAY_SHIFT  16
++#define AR934X_ETH_CFG_TXD_DELAY_MASK   0x3
++#define AR934X_ETH_CFG_TXD_DELAY_SHIFT  18
++#define AR934X_ETH_CFG_TXE_DELAY_MASK   0x3
++#define AR934X_ETH_CFG_TXE_DELAY_SHIFT  20
 +
 +/*
 + * QCA953X GMAC Interface