| 1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768 |
- --- a/drivers/gpio/Kconfig
- +++ b/drivers/gpio/Kconfig
- @@ -353,6 +353,13 @@ config GPIO_IXP4XX
- IXP4xx series of chips.
-
- If unsure, say N.
- +
- +config GPIO_LATCH
- + tristate "MikroTik RouterBOARD GPIO latch support"
- + depends on ATH79
- + help
- + GPIO driver for latch on some MikroTik RouterBOARDs.
- +
- config GPIO_LOGICVC
- tristate "Xylon LogiCVC GPIO support"
- depends on MFD_SYSCON && OF
- @@ -529,6 +536,10 @@ config GPIO_ROCKCHIP
- help
- Say yes here to support GPIO on Rockchip SoCs.
-
- +config GPIO_RB91X_KEY
- + tristate "MikroTik RB91x board series reset key support"
- + depends on ATH79
- +
- config GPIO_SAMA5D2_PIOBU
- tristate "SAMA5D2 PIOBU GPIO support"
- depends on MFD_SYSCON
- --- a/drivers/gpio/Makefile
- +++ b/drivers/gpio/Makefile
- @@ -75,6 +75,7 @@ obj-$(CONFIG_GPIO_IT87) += gpio-it87.o
- obj-$(CONFIG_GPIO_IXP4XX) += gpio-ixp4xx.o
- obj-$(CONFIG_GPIO_JANZ_TTL) += gpio-janz-ttl.o
- obj-$(CONFIG_GPIO_KEMPLD) += gpio-kempld.o
- +obj-$(CONFIG_GPIO_LATCH) += gpio-latch.o
- obj-$(CONFIG_GPIO_LOGICVC) += gpio-logicvc.o
- obj-$(CONFIG_GPIO_LOONGSON1) += gpio-loongson1.o
- obj-$(CONFIG_GPIO_LOONGSON) += gpio-loongson.o
- @@ -123,6 +124,7 @@ obj-$(CONFIG_GPIO_PMIC_EIC_SPRD) += gpio
- obj-$(CONFIG_GPIO_PXA) += gpio-pxa.o
- obj-$(CONFIG_GPIO_RASPBERRYPI_EXP) += gpio-raspberrypi-exp.o
- obj-$(CONFIG_GPIO_RB4XX) += gpio-rb4xx.o
- +obj-$(CONFIG_GPIO_RB91X_KEY) += gpio-rb91x-key.o
- obj-$(CONFIG_GPIO_RC5T583) += gpio-rc5t583.o
- obj-$(CONFIG_GPIO_RCAR) += gpio-rcar.o
- obj-$(CONFIG_GPIO_RDA) += gpio-rda.o
- --- a/drivers/mtd/nand/raw/Kconfig
- +++ b/drivers/mtd/nand/raw/Kconfig
- @@ -570,4 +570,10 @@ config MTD_NAND_RB4XX
- Enables support for the NAND flash chip on Mikrotik Routerboard
- RB4xx series.
-
- +config MTD_NAND_RB91X
- + tristate "MikroTik RB91x NAND driver support"
- + depends on ATH79 && MTD_RAW_NAND
- + help
- + Enables support for the NAND flash chip on MikroTik RB91x series.
- +
- endif # MTD_RAW_NAND
- --- a/drivers/mtd/nand/raw/Makefile
- +++ b/drivers/mtd/nand/raw/Makefile
- @@ -60,6 +60,7 @@ obj-$(CONFIG_MTD_NAND_ROCKCHIP) += rock
- obj-$(CONFIG_MTD_NAND_PL35X) += pl35x-nand-controller.o
- obj-$(CONFIG_MTD_NAND_AR934X) += ar934x_nand.o
- obj-$(CONFIG_MTD_NAND_RB4XX) += nand_rb4xx.o
- +obj-$(CONFIG_MTD_NAND_RB91X) += rb91x_nand.o
-
- nand-objs := nand_base.o nand_legacy.o nand_bbt.o nand_timings.o nand_ids.o
- nand-objs += nand_onfi.o
|
